4x100/1000 + 4x100/1000/2500 + 2x1G/10G SFP+ L3

PLANET MGS-6320-8T2X on 10-porttinen SNMP-hallittava Layer 3-tason kytkin, joka on varustettu 4x 10/100/1000Base-T, 4x 100/1000/2500Base-T sekä 2x SFP+ porttia 10/2.5/1G valokuitumoduleille.

Tekniset tiedot:
• 4x 10/100/1000BASE-T Gigabit Ethernet RJ45 (Port 1 to port4)
• 4x 10/100/1000/2500BASE-T Gigabit Ethernet RJ45 (Port 5 toport 8)
• 2x 10GBASE-X SFP+, backward compatible with 1000BASE-X and2500BASE-X SFP transceivers (Port 9 to port 10)
• RJ45 type RS232 console interface for switch basic management
• Layer 3 IP Routing Features
• IP dynamic routing protocol supports RIPv2, OSPFv2 and OSPFv3
• IPv4/IPv6 hardware static routing
• Routing interface provides per VLAN routing mode
• Layer2 Features
• High performance of Store-and-Forward architecture and runt/CRC filtering eliminates erroneous packets to optimize the network bandwidth
• Storm Control support
• Broadcast/Multicast/Unknown unicast
• Supports VLAN
• IEEE 802.1Q tagged VLAN
• Supports provider bridging (VLAN Q-in-Q, IEEE 802.1ad)
• Private VLAN Edge (PVE)
• Protocol-based VLAN
• MAC-based VLAN
• Voice VLAN
• GVRP (GARP VLAN Registration Protocol)
• Supports Spanning Tree Protocol
• IEEE 802.1D Spanning Tree Protocol
• IEEE 802.1w Rapid Spanning Tree Protocol
• IEEE 802.1s Multiple Spanning Tree Protocol, spanning treeby VLAN
• BPDU Guard
• Supports Link Aggregation
• 802.3ad Link Aggregation Control Protocol(LACP)
• Cisco ether-channel (static trunk)
• Maximum 4 trunk groups, up to 10 ports per trunk group
• Up to 40Gbps bandwidth (full duplex mode)
• Provides port mirror (many-to-1)
• Port mirroring to monitor the incoming or outgoing trafficon a particular port
• Loop protection to avoid broadcast loops
• Link Layer Discovery Protocol (LLDP)
• Compatible with Cisco uni-directional link detection(UDLD)that monitors a link between two switches and blocks the ports on both ends of the link if the link fails at any point between the two devices
• Supports G.8032 ERPS (Ethernet Ring Protection Switching)
• Quality of Service
• Ingress Shaper and Egress Rate Limit per port bandwidth control
• 8x priority queues on all switch ports
• Traffic classification
• IEEE 802.1p CoS
• TOS/DSCP/IP Precedence of IPv4/IPv6 packets
• IP TCP/UDP port number
• Typical network application
• Strict priority and Weighted Round Robin (WRR) CoS policies
• Supports QoS and In/Out bandwidth control on each port
• Traffic-policing on the switch port
• DSCP remarking
• Multicast
• Supports IPv4 IGMP Snooping v1, v2 and v3
• Supports IPv6 MLD Snooping v1 and v2
• Querier mode support
• IPv4 IGMP Snooping port filtering
• IPv6 MLD Snooping port filtering
• Multicast VLAN Registration (MVR) support
• Security
• Authentication
• IEEE 802.1x Port-based/MAC-based network access authentication
• Built-in RADIUS client to co-operate with the RADIUS servers
• TACACS+ login users access authentication
• RADIUS/TACACS+ users access authentication
• Guest VLAN assigns clients to a restricted VLAN with limited services
• Access Control List
• IP-based Access Control List (ACL)
• MAC-based Access Control List
• Source MAC/IP address binding
• DHCP Snooping to filter un-trusted DHCP messages
• Dynamic ARP Inspection discards ARP packets with invalid
• MAC address to IP address binding
• IP Source Guard prevents IP spoofing attacks
• IP address access management to prevent unauthorized intruder
• Management
• IPv4 and IPv6 dual stack management
• Switch Management Interfaces
• Web switch management
• Console and Telnet Command Line Interface
• SNMP v1 and v2c switch management
• SSHv2, TLSv1.2 and SNMPv3 secure access
• SNMP Management
• Four RMON groups (history, statistics, alarms and events)
• SNMP trap for interface Linkup and Linkdown notification
• IPv6 IP Address/NTP/DNS management
• Built-in Trivial File Transfer Protocol (TFTP) client
• BOOTP and DHCP for IP address assignment
• System Maintenance
• Firmware upload/download via HTTP/TFTP
• Reset button for system reboot or reset to factory default
• Dual Images
• DHCP Relay
• DHCP Option82
• User Privilege levels control
• NTP (Network Time Protocol)
• Network Diagnostic
• ICMPv6/ICMPv4 Remote Ping
• Cable Diagnostic technology provides the mechanism to detect and report potential cabling issues
• SFP-DDM (Digital Diagnostic Monitor)
• SMTP, Syslog and SNMP trap remote alarm
• System Log
• PLANET NMS system and Smart Discovery Utility for deployment management