PLANET TSN-6325-8T4S4X on aikakriittisiin toimintaympäristöihin suunniteltu 16-porttinen Industrial-tason hallittava DIN-kiskoon asennettava Etehernet-kytkin laajennetulla käyttölämpötila-alueella. L3
-kytkin on varustettu 8x 10/100/1000Base-T kupariportilla, 4x 100/1000 SFP- sekä 4x 10/2.5/1G SFP/SFP+ portilla.

Tekniset tiedot – 8x 10/100/1000BASE-T RJ45 copper ports – 4x 100/1000/2500BASE-X SFP slots for SFP type auto detection – 4x 10GBASE-SR/LR SFP+ slots, compatible with 1000BASE-X and 2500BASE-X SFP – One RJ45-to-RS232 console interface for basic management and setup – Dual power input, redundant power with reverse polarity protection – 9…48VDC input or AC 24V input – Active-active redundant power failure protection – Backup of catastrophic power failure on one supply – Fault tolerance and resilience – DIN-rail and wall-mountable designs – IP30 aluminum case – Supports 6000VDC Ethernet ESD protection – -40…+75 degrees C operating temperature – 2x digital input (DI) – 2x digital output (DO) – Integrates sensors into auto alarm system – Transfers alarm to IP network via email and SNMP trap – Time Sensitive Networking
– High Precision Time Synchronization
– IEEE1588 (Time Stamping)
– 802.1AS-Rev gPTP default profile
– Shapers
– 802.1Qbv Enhancements for Scheduled Traffic
– 802.1Qch (Cyclic Queuing and Forwarding)
– TSN Stream Policing
– 802.1Qci (Per Stream Filtering and Policing)
– Redundancy
– 802.1CB FRER for seamless redundancy
– Also standard Linear and Ring protection
– Delay Reduction
– IEEE 802.1Qbu Frame Preemption
– IEEE 802.3br Interspersing Express Traffic (IET) – Layer 3 IP Routing Features – IPv4 dynamic routing protocol supports RIPv2 and OSPFv2 and IPv6 OSPFv3 – IPv6 dynamic routing protocol supports OSPFv3 – IPv4/IPv6 hardware static routing – Routing interface provides per VLAN routing mode – Layer 2 Features – High performance of Store-and-Forward architecture, and runt/CRC filtering eliminates erroneous packets to optimize the network bandwidth – Storm control support – Broadcast/Multicast/Unknown unicast – Supports VLAN – IEEE 802.1Q tagged VLAN – Supports provider bridging (VLAN Q-in-Q IEEE 802.1ad) – Private VLAN Edge (PVE) – Protocol-based VLAN – MAC-based VLAN – Voice VLAN – GVRP (GARP VLAN Registration Protocol) – Supports Spanning Tree Protocol – IEEE 802.1D Spanning Tree Protocol (STP) – IEEE 802.1w Rapid Spanning Tree Protocol (RSTP) – IEEE 802.1s Multiple Spanning Tree Protocol (MSTP), spanning tree by VLAN – BPDU Guard – Supports Link Aggregation – 802.3ad Link Aggregation Control Protocol (LACP) – Cisco ether-channel (static trunk) – Maximum 8 trunk groups, with 16 ports for each trunk – Provides port mirror (many-to-1) – Port mirroring to monitor the incoming or outgoing trafficon a particular port – Loop protection to avoid broadcast loops – Link Layer Discovery Protocol (LLDP) – Compatible with Cisco uni-directional link detection(UDLD)that monitors a link between two switches and blocks the ports on both ends of the link if the link fails at any point between the two devices – Supports G.8032 ERPS (Ethernet Ring Protection Switching) – IEEE 1588v2 PTP (Precision Time Protocol) – Features IEEE 802.1AS Time Synchronization, IEEE 802.1Qbu – Frame Preemption, IEEE 802.1Qbv Enhancements for ScheduledTraffic and IEEE 802.1CB Seamless Redundancy – Quality of Service – Ingress shaper and egress rate limit per port bandwidth control – 8 priority queues on all switch ports – Traffic classification – IEEE 802.1p CoS – ToS/DSCP/IP Precedence of IPv4/Ipv6 packets – IP TCP/UDP port number – Typical network application – Strict priority and Weighted Round Robin (WRR) CoS policies – Supports QoS and In/Out bandwidth control on each port – Traffic-policing on the switch port – DSCP remarking – Voice VLAN – Supports IPv4 IGMP snooping v1, v2 and v3 – Supports IPv6 MLD snooping v1 and v2 – Querier mode support – IPv4 IGMP snooping port filtering – IPv6 MLD snooping port filtering – MVR (Multicast VLAN Registration) – Authentication – IEEE 802.1x port-based/MAC-based network access authentication – IEEE 802.1x authentication with guest VLAN – Built-in RADIUS client to cooperate with the RADIUS servers – RADIUS/TACACS+ users access authentication – Guest VLAN assigns clients to a restricted VLAN with limited services – Access Control List – IP-based Access Control List (ACL) – MAC-based Access Control List (ACL) – Source MAC/IP address binding – DHCP Snooping to filter distrusted DHCP messages – Dynamic ARP Inspection discards ARP packets with invalid – MAC address to IP address binding – IP Source Guard prevents IP spoofing attacks – IP address access management to prevent unauthorized intruder – IPv4 and IPv6 dual stack management – Switch Management Interfaces – Console and Telnet Command Line Interface – HTTP web switch management – SNMP v1 and v2c switch management – SSHv2, TLSv1.2 and SNMPv3 secure access – SNMP Management – Four RMON groups (history, statistics, alarms, and events)– SNMP trap for interface Link Up and Link Down notification– IPv6 IP address/NTP/DNS management – Built-in Trivial File Transfer Protocol (TFTP) client – BOOTP and DHCP for IP address assignment – System Maintenance – Firmware upload/download via HTTP – Reset button for system reboot or reset to factory default– Dual images – DHCP Functions:
– DHCP Relay
– DHCP Option82
– DHCP Server – User Privilege levels control – Network Time Protocol (NTP) – Network Diagnostic – SFP-DDM (Digital Diagnostic Monitor) – ICMPv6/ICMPv4 remote ping – SMTP/Syslog remote alarm – System Log – PLANET Smart Discovery Utility for deployment management – PLANET UNI-NMS (Universal Network Management) and – CloudViewer app for deployment management