PLANET MGS-6320-8HP2X on 10-porttinen SNMP-hallittava Layer 3-tason UltraPoE-kytkin 240W virransyöttökapasiteetilla. Kytkin on varustettu 4x 10/100/1000Base-T PoE+ sekä 4x 100/1000/2500Base-T UltraPoE++ portilla. Kupariporttien lisäksi kytkimessä on 2x SFP+ porttia 10/2.5/1G valokuitumoduleille.

Tekniset tiedot:
• 4x 10/100/1000BASE-T with 36W 802.3at PoE+ injector function (Port-1 to Port-4)
• 4x 10/100/1000/2500BASE-T with 90W 802.3bt PoE++ injector function (Port-5 to Port-8)
• 2x 10GBASE-X SFP+, backward compatible with 1000BASE-X and2500BASE-X SFP transceivers
• RJ45 type RS232 console interface for switch basic management
• 4x PoE ports with 802.3at PoE+ inject built-in (Port-1 to Port-4)
• 4x PoE ports with 802.3bt PoE++ inject built-in (Port-5 toPort-8)
• Provides up to 95W to 802.3bt/PoH powered devices
• Maximum 240W PoE budget
• Auto detects powered device(PD)
• Remote power feeding up to 100M
• PoE Isolation
• Circuit protection prevents power interference between ports
• PoE Management
– PoE admin-mode control
– PoE usage threshold
– Temperature threshold
– PoE Port Status monitoring
– PD classification detection
– Per port PoE function enable/disable
– Per PoE port power limit
– PoE Port Power feeding priority
– PoE extend mode control to support power feeding up to a distance of up to 200 meters
• Intelligent PoE features
• Temperature threshold control
• PoE usage threshold control
• PD alive check
• PoE schedule
• IP dynamic routing protocol supports RIPv2, OSPFv2 and OSPFv3
• IPv4/IPv6 hardware static routing
• Routing interface provides per VLAN routing mode
• High performance of Store-and-Forward architecture and runt/CRC filtering eliminates erroneous packets to optimize the network bandwidth
• Storm Control support
– Broadcast/Multicast/Unknown unicast
• Supports VLAN
– IEEE 802.1Q tagged VLAN
– Supports provider bridging (VLAN Q-in-Q, IEEE 802.1ad)
– Private VLAN Edge (PVE)
– Protocol-based VLAN
– MAC-based VLAN
– Voice VLAN
– GVRP(GARP VLAN Registration Protocol)
• Supports Spanning Tree Protocol
– IEEE 802.1D Spanning Tree Protocol
– IEEE 802.1w Rapid Spanning Tree Protocol
– IEEE 802.1s Multiple Spanning Tree Protocol, spanning treeby VLAN
– BPDU Guard
• Supports Link Aggregation
– 802.3ad Link Aggregation Control Protocol(LACP)
– Cisco ether-channel (static trunk)
– Maximum 4 trunk groups, up to 10 ports per trunk group
– Up to 40Gbps bandwidth (full duplex mode)
• Provides port mirror (many-to-1)
• Port mirroring to monitor the incoming or outgoing trafficon a particular port
• Loop protection to avoid broadcast loops
• Link Layer Discovery Protocol (LLDP)
• Compatible with Cisco uni-directional link detection(UDLD)that monitors a link between two switches and blocks the ports on both ends of the link if the link fails at any point between the two devices
• Supports G.8032 ERPS (Ethernet Ring Protection Switching)
• Ingress Shaper and Egress Rate Limit per port bandwidth control
• 8x priority queues on all switch ports
• Traffic classification
– IEEE 802.1p CoS
– TOS/DSCP/IP Precedence of IPv4/IPv6 packets
– IP TCP/UDP port number
– Typical network application
• Strict priority and Weighted Round Robin (WRR) CoS policies
• Supports QoS and In/Out bandwidth control on each port
• Traffic-policing on the switch port
• DSCP remarking
• Supports IPv4 IGMP Snooping v1, v2 and v3
• Supports IPv6 MLD Snooping v1 and v2
• Querier mode support
• IPv4 IGMP Snooping port filtering
• IPv6 MLD Snooping port filtering
• Multicast VLAN Registration (MVR) support
• Authentication
– IEEE 802.1x Port-based/MAC-based network access authentication
– Built-in RADIUS client to co-operate with the RADIUS servers
– TACACS+ login users access authentication
– RADIUS/TACACS+ users access authentication
• Access Control List
– IP-based Access Control List (ACL)
– MAC-based Access Control List
• Source MAC/IP address binding
• DHCP Snooping to filter un-trusted DHCP messages
• Dynamic ARP Inspection discards ARP packets with invalid
• MAC address to IP address binding
• IP Source Guard prevents IP spoofing attacks
• IP address access management to prevent unauthorized intruder
• IPv4 and IPv6 dual stack management
• Switch Management Interfaces
– Web switch management
– Console and Telnet Command Line Interface
– SNMP v1 and v2c switch management
– SSHv2, TLSv1.2 and SNMPv3 secure access
• SNMP Management
– Four RMON groups (history, statistics, alarms and events)
– SNMP trap for interface Linkup and Linkdown notification
• IPv6 IP Address/NTP/DNS management
• Built-in Trivial File Transfer Protocol (TFTP) client
• BOOTP and DHCP for IP address assignment
• System Maintenance
– Firmware upload/download via HTTP/TFTP
– Reset button for system reboot or reset to factory default
– Dual Images
• DHCP Relay
• DHCP Option82
• User Privilege levels control
• NTP (Network Time Protocol)
• Network Diagnostic
– ICMPv6/ICMPv4 Remote Ping
– Cable Diagnostic technology provides the mechanism to detect and report potential cabling issues
– SFP-DDM (Digital Diagnostic Monitor)
• SMTP, Syslog and SNMP trap remote alarm
• System Log
• PLANET Smart Discovery Utility for deployment management
• PLANET UNI-NMS (Universal Network Management) and Smart
• Discovery Utility for deployment management
• Provides ONVIF for co-operating with PLANET video IP