PLANET WS-1032P on langattomien WiFi-tukiasemien hallintakytkin (controller), joka tarjoaa älykkään tukiasemahallinnan, Layer 3 reitityksen sekä PoE+ ominaisuudet. Keskitin mahdollistaa palveluntarjoajien ja IT-päälliköiden hallita kaikkia langattomia tukiasemia samanaikaisesti pienissä ja keskisuurissa langattomissa verkkoympäristöissä, kuten hotelleissa, huviloissa, lomakeskuksissa ja muilla julkisilla alueilla.
WS-1032P tarjoaa IPv6/IPv4-hallinnan ja sisäänrakennetun L2/L4 Gigabit kytkimen, johon kuuluu 8x 10/100/1000BASE-T- porttia, joissa on 36W 802.3at PoE+, sekä 2x ylimääräistä 1/2.5/10 Gigabit BASE-X SFP+ -kuituliitäntää uplink- yhteyksiin. Tuetut tukiasemamallit:
• WDAP-C3000AX
• WDAP-3000AX
• WDAP-W3000AX
• IAP-1800AX
• IAP-2400AX
• WDAP-W1800AXU
• WDAP-C1800AX
• WDAP-1800AX
Tekniset tiedot:
• 8-port 10/100/1000BASE-T with 36W PoE injector
• 2-port 1/2.5/10GBASE-X SFP+
• RS232 RJ45 console interface for switch basic management and setup
• Wireless LAN AP Management
• Dashboard: provides at-a-glance view of system and wireless network status
• AP Discovery: one key to discover the managed APs on the managed LAN
• Customized Profile: allows multiple wireless profiles creation and maintenance
• Auto Provision: multi-AP provisioning with one click
• Cluster Management: simplifies high-density AP management
• Zone Plan: optimizes AP deployment with actual signal coverage
• Analysis: real-time AP status monitoring
• Scalability: free system upgrade and AP firmware bulk upgrade capability
• Power over Ethernet
• Up to 8 ports of IEEE 802.3af/802.3at devices powered
• Supports PoE Power up to 36 watts for each PoE port
• Auto detects powered device (PD)
• Circuit protection prevents power interference between ports
• Remote power feeding up to 100 meters
• PoE management features
• Total PoE power budget control
• Per port PoE function enable/disable
• PoE admin-mode control
• PoE port power feeding priority
• Per PoE port power limit
• PD classification detection
• Intelligent PoE features
• Temperature threshold control
• PoE usage threshold control
• PD alive check
• PoE schedule
• Layer 3 IP Routing Features
• IP dynamic routing protocol supports RIPv2, OSPFv2 and OSPFv3
• IPv4/IPv6 hardware static routing
• Routing interface provides per VLAN routing mode
• Layer2 Features
• High performance of Store-and-Forward architecture and runt/CRC filtering eliminates erroneous packets to optimize the network bandwidth
• Storm Control support
• Broadcast/Multicast/Unknown unicast
• Supports VLAN
• IEEE 802.1Q tagged VLAN
• Supports provider bridging (VLAN Q-in-Q, IEEE 802.1ad)
• Private VLAN Edge (PVE)
• Protocol-based VLAN
• MAC-based VLAN
• Voice VLAN
• GVRP(GARP VLAN Registration Protocol)
• Supports Spanning Tree Protocol
• STP, IEEE 802.1D Spanning Tree Protocol
• RSTP, IEEE 802.1w Rapid Spanning Tree Protocol
• MSTP, IEEE 802.1s Multiple Spanning Tree Protocol, spanning tree by VLAN
• BPDU Guard
• Supports Link Aggregation
• 802.3ad Link Aggregation Control Protocol(LACP)
• Cisco ether-channel (static trunk)
• Maximum 5 trunk groups, up to 10 ports per trunk group
• Up to 56Gbps bandwidth (full duplex mode)
• Provide sport mirror (many-to-1)
• Port mirroring to monitor the incoming or outgoing trafficon a particular port
• Loop protection to avoid broadcast loops
• Link Layer Discovery Protocol (LLDP)
• Compatible with Cisco uni-directional link detection (UDLD) that monitors a link between two switches and blocks the ports on both ends of the link if the link fails at any point between the two devices
• Supports G.8032 ERPS (Ethernet Ring Protection Switching)
• Quality of Service
• Ingress Shaper and Egress Rate Limit per port bandwidth control
• 8 priority queues on all switch ports
• Traffic classification
• IEEE 802.1p CoS
• TOS/DSCP/IP Precedence of IPv4/IPv6 packets
• IP TCP/UDP port number
• Typical network application
• Strict priority and Weighted Round Robin (WRR) CoS policies
• Supports QoS and In/Out bandwidth control on each port
• Traffic-policing policies on the switch port
• DSCP remarking
• Supports IPv4 IGMP Snooping v1, v2 and v3
• Supports IPv6 MLD Snooping v1 and v2
• Querier mode support
• IGMP Snooping port filtering
• MLD Snooping port filtering
• Multicast VLAN Registration (MVR) support
• Security
• Authentication
• IEEE 802.1x Port-based/MAC-based network access authentication
• Built-in RADIUS client to co-operate with the RADIUS servers
• TACACS+ login users access authentication
• RADIUS/TACACS+ users access authentication
• Access Control List
• IP-based Access Control List (ACL)
• MAC-based Access Control List
• Source MAC/IP address binding
• DHCP Snooping to filter un-trusted DHCP messages
• Dynamic ARP Inspection discards ARP packets with invalid
• MAC address to IP address binding
• IP Source Guard prevents IP spoofing attacks
• Auto DoS rule to defend DoS attack
• IP address access management to prevent unauthorized intruder
• Management
• IPv4 and IPv6 dual stack management
• Switch Management Interfaces
• Console/Telnet Command Line Interface
• Web switch management
• SNMP v1, v2c, and v3 switch management
• SSHv2, TLSv1.2 secure access
• IPv6 IP Address/NTP/DNS management
• Built-in Trivial File Transfer Protocol (TFTP) client
• BOOTP and DHCP for IP address assignment |
