PLANET IGS-6325-20T4C4X on teollisuuskäyttöön suunniteltu 28-porttinen hallittava 19″ Etehernet-kytkin laajennetulla käyttölämpötila-alueella. L3-kytkin on varustettu 14x 100/1000Base-X SFP-moduulipaikalla, 4x 100/1000/2500Base-X SFP-moduulipaikalla, 4x jaetulla 10/100/1000Base-T kupariportilla sekä 4x 10G SFP+ portilla. Kytkimessä on lisäksi kehittyneemmät hallintapuolen turvaominaisuudet sekä IEEE 1588 PTP aikaprotokollatuki aikakriittisisiin sovelluksiin.

Tekniset tiedot – 14x 100/1000BASE-X SFP slots – 10x 100/1000/2500BASE-X SFP slots – 4x 10/100/1000BASE-T RJ45 ports, shared with Port-1 to Port-4 – 4x 10GBASE-SR/LR SFP+ slots, compatible with 1000BASE- SX/LX/BX and 2500BASE-X SFP ports 25-28 – RJ45 to RS232 console interface for basic management and setup – One 100 to 240V ACor dual 24 to 60VDC power input, redundant power with polarity reverse protect function
– Active-active redundant power failure protection
– Backup of catastrophic power failure on one supply
– Fault tolerance and resilience – 19″ rack-mountable design – IP30 metal case – Supports EFT 6000VDC protection and 6000VDC Ethernet ESD protection – -40…+75C operating temperature for DC power input – -10…+60C operating temperature for AC power input – 2x Digital Input (DI) – 2x Digital Output (DO) – Integrates sensors into auto alarm system – Transfers alarm to IP network via email and SNMP trap – Supports maximum 128 static routes and route summarization– IP dynamic routing protocol supports OSPFv2 – Routing interface provides per VLAN routing mode – High performance of Store-and-Forward architecture, and runt/CRC filtering eliminates erroneous packets to optimize the network bandwidth – Storm control support
– Broadcast/Multicast/Unknown unicast Supports VLAN
– IEEE 802.1Q tagged VLAN
– Up to 4K VLANs groups, out of 4096 VLAN IDs
– Provides Bridging (VLAN Q-in-Q) support (IEEE 802.1ad)
– Private VLAN Edge (PVE)
– Protocol-based VLAN
– MAC-based VLAN
– IP subnet-based VLAN
– GVRP – Supports Spanning Tree Protocol
– IEEE 802.1D Spanning Tree Protocol (STP)
– IEEE 802.1w Rapid Spanning Tree Protocol (RSTP)
– IEEE 802.1s Multiple Spanning Tree Protocol (MSTP), spanning tree by VLAN
– BPDU Guard – Supports Link Aggregation
– 802.3ad Link Aggregation Control Protocol (LACP)
– Cisco ether-channel (static trunk)
– Maximum 14 trunk groups, with 16 ports for each trunk
– Up to 80Gbps bandwidth (full duplex mode) – Provides port mirror (many-to-1) – Port mirroring monitors the incoming or outgoing traffic on a particular port – Loop protection to avoid broadcast loops – Supports ERPS (Ethernet Ring Protection Switching) – Compatible with Cisco Uni-directional link detection(UDLD)that monitors a link between two switches and blocks the ports on both ends of the link if the link fails at any point between the two devices – IEEE 1588 and Synchronous Ethernet network timing – Ingress shaper and egress rate limit per port bandwidth control – 8x priority queues on all switch ports – Traffic classification
– IEEE 802.1p CoS
– ToS/DSCP/IP Precedence of IPv4/IPv6 packets
– IP TCP/UDP port number
– Typical network application – Strict priority and Weighted Round Robin (WRR) CoS policies – Traffic policing on the switch port – DSCP remarking – Voice VLAN – Supports IPv4 IGMP snooping v1, v2 and v3 – Supports IPv6 MLD snooping v1 and v2 – Querier mode support – IPv4 IGMP snooping port filtering – IPv6 MLD snooping port filtering – MVR (Multicast VLAN Registration) – Authentication
– IEEE 802.1x port-based/MAC-based network access authentication
– IEEE 802.1x authentication with guest VLAN
– Built-in RADIUS client to cooperate with the RADIUS servers
– RADIUS/TACACS+ users access authentication – Access Control List
– IP-based Access Control List (ACL)
– MAC-based Access Control List (ACL) – Source MAC/IP address binding – DHCP Snooping to filter distrusted DHCP messages – Dynamic ARP Inspection discards ARP packets with invalid MAC address to IP address binding – IP Source Guard prevents IP spoofing attacks – IP address access management to prevent unauthorized intruder – IPv4 and IPv6 dual stack management – Switch Management Interfaces
– Console/Telnet command line interface
– Web switch management
– SNMP v1, v2c, and v3 switch management
– SSH, TLS, SSL secure access – SNMP Management
– Four RMON groups (history, statistics, alarms, and events)
– SNMP trap for interface Link Up and Link Down notification– IPv6 address/NTP management – Built-in Trivial File Transfer Protocol (TFTP) client – BOOTP and DHCP for IP address assignment – System Maintenance
– Firmware upload/download via HTTP/TFTP
– Reset button for system reboot or reset to factory default
– Dual images – DHCP relay and option 82 – DHCP Server – User privilege levels control – NTP (Network Time Protocol) – Link Layer Discovery Protocol (LLDP) and LLDP-MED – Network diagnostic
– SFP-DDM (Digital Diagnostic Monitor)
– Cable diagnostic technology provides the mechanism to detect and report potential cabling issues
– ICMPv6/ICMPv4 remote ping – SMTP/Syslog remote alarm – Four RMON groups (history, statistics, alarms and events) – SNMP trap for interface link up and link down notification– System Log – PLANET Smart Discovery Utility for deployment management