Kestävä IP30-suojattu metallikotelo, DIN-kisko- ja seinäkiinnitysmahdollisuus sekä laajennettu käyttölämpötila-alue (-40…+75C) tekevät siitä luotettavan ratkaisun vaativiin teollisuusympäristöihin ja runkoverkkoihin. Laitteen 116 Gbit/s kytkentäkangas ja wire-speed-läpivienti mahdollistavat erittäin suuren kapasiteetin ja vakauden myös raskaissa sovelluksissa.

TSN-6325-8T4S4X tukee IEEE 1588v2 PTP-aikasynkronointia kaikissa porteissa sekä keskeisiä TSN-standardeja, kuten IEEE 802.1AS-Rev, 802.1Qbv, 802.1Qbu, 802.3br, 802.1Qci ja 802.1CB. Tämä mahdollistaa erittäin pienen viiveen ja luotettavan reaaliaikaisen tiedonsiirron, mikä tekee laitteesta erinomaisen valinnan Industry 4.0 -sovelluksiin, 5G NR -tukiasemien liityntöihin, Wi-Fi 6/6E -tukiasemiin, 4K/8K-videostriimaukseen ja VR/AR-ympäristöihin.

Laite tukee Layer 3 IP-reititystä (staattinen reititys, RIP, OSPF), ERPS-rengassuojausta, MSTP:tä, VLAN-ominaisuuksia, LACP-linkkiaggregaatiota sekä suojaustoimintoja, kuten ACL, 802.1X, DHCP Snooping ja IP Source Guard. Lisäksi siinä on Boundary Clock- ja Transparent Clock -tilat aikakriittisiin sovelluksiin sekä kattavat redundanssi- ja hallintaominaisuudet.

Tuotepakkaus sisältää TSN-6325-8T4S4X-kytkimen, DIN- kiskokiinnikkeen (esiasennettuna), seinäkiinnityslevyn ja ruuvit, RJ45-DB9 RS232-konsolikaapelin sekä englanninkielisen pikaoppaan.

Tekniset tiedot:
• 8x 10/100/1000BASE-T RJ45 copper ports
• 4x 1000/2500BASE-X SFP slots for SFP type auto detection
• 4x 10GBASE-SR/LR SFP+ slots, compatible with 1000BASE-X and 2500BASE-X SFP
• 1x RJ45-to-RS232 console interface for basic management and setup
• Dual power input, redundant power with reverse polarity protection:
– 9…48VDC input or 24VAC input
– Active-active redundant power failure protection
– Backup of catastrophic power failure on one supply
– Fault tolerance and resilience
• DIN-rail and wall-mountable designs
• IP30 aluminum case
• Supports 6000VDC Ethernet ESD protection
• -40…+75C operating temperature
• 2 digital input (DI)
• 2 digital output (DO)
• Integrates sensors into auto alarm system
• Transfers alarm to IP network via email and SNMP trap
• High Precision Time Synchronization:
– IEEE1588 (Time Stamping)
– 802.1AS-Rev gPTP default profile
• Shapers:
– 802.1Qbv Enhancements for Scheduled Traffic
– 802.1Qch (Cyclic Queuing and Forwarding)
• TSN Stream Policing:
– 802.1Qci (Per Stream Filtering and Policing)
• Redundancy:
– 802.1CB FRER for seamless redundancy
– Also standard Linear and Ring protection
• Delay Reduction:
– IEEE 802.1Qbu Frame Preemption,
– IEEE 802.3br Interspersing Express Traffic (IET)
• IPv4 dynamic routing protocol supports RIPv2 and OSPFv2 and IPv6 OSPFv3
• IPv6 dynamic routing protocol supports OSPFv3
• IPv4/IPv6 hardware static routing
• Routing interface provides per VLAN routing mode
• High performance of Store-and-Forward architecture, and runt/CRC filtering eliminates erroneous packets to optimize the network bandwidth
• Storm control support:
– Broadcast/Multicast/Unknown unicast
• Supports VLAN:
– IEEE 802.1Q tagged VLAN
– Supports provider bridging (VLAN Q-in-Q IEEE 802.1ad)
– Private VLAN Edge (PVE)
– Protocol-based VLAN
– MAC-based VLAN
– Voice VLAN
– GVRP (GARP VLAN Registration Protocol)
• Supports Spanning Tree Protocol
– IEEE 802.1D Spanning Tree Protocol (STP)
– IEEE 802.1w Rapid Spanning Tree Protocol (RSTP)
– IEEE 802.1s Multiple Spanning Tree Protocol (MSTP), spanning tree by VLAN
– BPDU Guard
• Supports Link Aggregation:
– 802.3ad Link Aggregation Control Protocol (LACP)
– Cisco ether-channel (static trunk)
– Maximum 8 trunk groups, with 16 ports for each trunk
• Provides port mirror (many-to-1)
• Port mirroring to monitor the incoming or outgoing trafficon a particular port
• Loop protection to avoid broadcast loops
• Link Layer Discovery Protocol (LLDP)
• Compatible with Cisco uni-directional link detection(UDLD)that monitors a link between two switches and blocks the ports on both ends of the link if the link fails at any point between the two devices
• Supports G.8032 ERPS (Ethernet Ring Protection Switching)
• IEEE 1588v2 PTP (Precision Time Protocol)
• Features IEEE 802.1AS Time Synchronization, IEEE 802.1Qbu Frame Preemption, IEEE 802.1Qbv Enhancements for Scheduled Traffic and IEEE 802.1CB Seamless Redundancy
• Ingress shaper and egress rate limit per port bandwidth control
• 8 priority queues on all switch ports
• Traffic classification:
– IEEE 802.1p CoS
– ToS/DSCP/IP Precedence of IPv4/Ipv6 packets
– IP TCP/UDP port number
– Typical network application
• Strict priority and Weighted Round Robin (WRR) CoS policies
• Supports QoS and In/Out bandwidth control on each port
• Traffic-policing on the switch port
• DSCP remarking
• Voice VLAN
• Supports IPv4 IGMP snooping v1, v2 and v3
• Supports IPv6 MLD snooping v1 and v2
• Querier mode support
• IPv4 IGMP snooping port filtering
• IPv6 MLD snooping port filtering
• MVR (Multicast VLAN Registration)
• Authentication:
– IEEE 802.1x port-based/MAC-based network access authentication
– IEEE 802.1x authentication with guest VLAN
– Built-in RADIUS client to cooperate with the RADIUS servers
– RADIUS/TACACS+ users access authentication