PLANET GS-6322-48UP4X on hallittava ja pinottava Layer 3 – tason PoE-kytkin, jossa on 48x 10/100/1000BASE-T 802.3bt PoE++-porttia sekä 4x 10G SFP+-porttia, ja kaksi modulaarista virtalähdepaikkaa.

GS-6322-48UP4X tukee jopa 95W tehoa per portti (IEEE 802.3btType 4) ja tarjoaa kokonaispoe-budjetin jopa 3200 wattia, mikä tekee siitä erinomaisen ratkaisun vaativiin sovelluksiin, kuten PTZ-kameroihin, langattomiin tukiasemiin, infonäyttöihin ja PoE-valaistukseen. Laite tukee sekä redundanttia (RPS) että laajennettua (EPS) virtalähdekonfiguraatiota.

Kytkin tukee IPv4/IPv6-reititystä, OSPFv2:ta, kehittyneitä suojausominaisuuksia (ACL, 802.1X, DHCP Snooping, IP Source Guard) sekä rengassuojausta (ITU-T G.8032 ERPS) ja MSTP:tä. ONVIF-tuki helpottaa IP-valvontalaitteiden hallintaa, ja PoE-hallintaominaisuudet, kuten PD Alive Check ja ajastettu virrankierrätys, parantavat luotettavuutta ja energiatehokkuutta.

Tuotepakkaus sisältää kytkimen lisäksi kumitassut, 19″ räkkikiinnikkeet sekä englanninkielisen pikaoppaan.

Ei sisällä virtalähdettä. Yhteensopivia ovat mm. PLANET PWR-CRPS920, PWR-CRPS1200 ja PWR-CRPS2000.

Tekniset tiedot:
• 48x 10/100/1000BASE-T Gigabit RJ45 copper ports with 48- port IEEE 802.3bt PoE++ injector function
• 4x 10GBASE-SR/LR SFP+ slots, compatible with 1000BASE- SX/LX/BX SFP and 2.5G SFP transceiver
• 1x USB Type C console interface for switch basic management and setup
• Complies with IEEE 802.3bt Power over Ethernet Plus Plus
• Backward compatible with IEEE 802.3at Power over Ethernet Plus
• Up to 48 ports of IEEE 802.3af/IEEE 802.3at/IEEE 802.3bt PoE devices powered
• 48x PoE ports with built-in 802.3bt PoE++ 95W injector function
• Auto detects powered device (PD)
• Circuit protection prevents power interference between ports
• Remote power feeding up to 100 meters
• PoE management features:
– Total PoE power budget control
– Per port PoE function enable/disable
– PoE admin-mode control
– PoE port power feeding priority
– Per PoE port power limit
– PD classification detection
– PoE extend mode control to support power feeding up to 200meters
• Intelligent PoE features
– Temperature threshold control
– PoE usage threshold control
– PD alive check
– PoE schedule
• IP dynamic routing protocol supports RIPv2, OSPFv2 and OSPFv3
• IPv4/IPv6 hardware static routing
• Routing interface provides per VLAN routing mode
• IP interfaces (Max. 128 VLAN interfaces)
• Routing table (Max. 128 routing entries)
• Prevents packet loss with back pressure (half-duplex) and IEEE 802.3x pause frame flow control (full-duplex)
• High performance of Store-and-Forward architecture and runt/CRC filtering eliminates erroneous packets to optimize the network bandwidth
• Storm Control support:
– Broadcast/multicast/unknown unicast
• Supports VLAN:
– IEEE 802.1Q tagged VLAN
– Out of 4096 VLAN IDs
– Supports provider bridging (VLAN Q-in-Q, IEEE 802.1ad)
– Private VLAN Edge (PVE)
– Protocol-based VLAN
– MAC-based VLAN
– Voice VLAN
– GVRP (GARP VLAN Registration Protocol)
• Supports Spanning Tree Protocol:
– IEEE 802.1D Spanning Tree Protocol (STP)
– IEEE 802.1w Rapid Spanning Tree Protocol (RSTP)
– IEEE 802.1s Multiple Spanning Tree Protocol (MSTP), Spanning Tree by VLAN
– BPDU Guard
• Supports Link Aggregation
– 802.3ad Link Aggregation Control Protocol (LACP)
– Cisco ether-channel (static trunk)
– Maximum 4 trunk groups with 4 ports for each trunk group -Up to 80Gbps bandwidth (full duplex mode)
• Provides port mirror (many-to-1)
• Port mirroring to monitor the incoming or outgoing trafficon a particular port
• Loop protection to avoid broadcast loops
• Supports ERPS (Ethernet Ring Protection Switching)
• Compatible with Cisco uni-directional link detection (UDLD) that monitors a link between two switches and blocks the ports on both ends of the link if the link fails at any point between the two devices
• Link Layer Discovery Protocol (LLDP)
• Ingress Shaper and Egress Rate Limit per port bandwidth control
• 8 priority queues on all switch ports
• Traffic classification:
– IEEE 802.1p CoS
– TOS/DSCP/IP precedence of IPv4/IPv6 packets
– IP TCP/UDP port number
– Typical network application
• Strict priority and Weighted Round Robin (WRR) CoS policies
• Supports QoS and In/Out bandwidth control on each port
• Traffic-policing on the switch port
• DSCP remarking
• Supports IPv4 IGMP snooping v1, v2 and v3
• Supports IPv6 MLD snooping v1 and v2
• Querier mode support
• IPv4 IGMP snooping port filtering
• IPv6 MLD snooping port filtering
• Multicast VLAN Registration (MVR) support
• Authentication:
– IEEE 802.1x port-based/MAC-based network access authentication
– Built-in RADIUS client to cooperate with the RADIUS servers
– TACACS+ login users access authentication
– RADIUS/TACACS+ users access authentication -Guest VLAN assigns clients to a restricted VLAN with limited services.
• Access Control List:
– IP-based Access Control List (ACL)
– MAC-based Access Control List
• Source MAC/IP address binding
• DHCP Snooping to filter untrusted DHCP messages
• Dynamic ARP Inspection discards ARP packets with invalid
• MAC address to IP address binding
• IP Source Guard prevents IP spoofing attacks
• IP address access management to prevent unauthorized intruder
• IPv4 and IPv6 dual stack management
• Switch Management Interfaces:
– Console/Telnet Command Line Interface
– Web switch management
– SNMP v1, v2c, and v3 switch management