PLANET IGS-5225-16T4S on teollisuuskäyttöön suunniteltu 20-porttinen hallittava 19″ Ethernet-kytkin laajennetulla käyttölämpötila-alueella. Kytkin on varustettu 16x 10/100/1000Base-T kupariportilla sekä 4x 100/1000M SFP- porteilla.

Tekniset tiedot:
• 16x 10/100/1000BASE-T RJ45 copper
• 4x 100/1000BASE-X SFP slots, compatible with 100BASE-FX SFP
• RJ45 to RS232 DB9 console interface for basic management and setup
• One 100 to 240VAC or dual 36 to 60V DC power input, redundant power with polarity reverse protection function
– Active-active redundant power failure protection
– Backup of catastrophic power failure on one supply
– Fault tolerance and resilience
• 19-inch rack-mountable design
• IP30 metal case
• Supports 6000V DC Ethernet ESD protection
• -40…+75C operating temperature for DC power input
• -10…+60 degrees C operating temperature for AC power input
• 2 Digital Input (DI)
• 2 Digital Output (DO)
• Integrates sensors into auto alarm system
• Transfers alarm to IP network via email and SNMP trap
• Supports maximum 32 static routes and route summarization
• Prevents packet loss with back pressure (half-duplex) and IEEE 802.3x pause frame flow control (full-duplex)
• High performance of Store-and-Forward architecture, and runt/CRC filtering eliminates erroneous packets to optimize the network bandwidth
• Storm control support
– Broadcast/Multicast/Unknown unicast
• Supports VLAN
– IEEE 802.1Q tagged VLAN
– Up to 255 VLANs groups, out of 4095 VLAN IDs
– Provides Bridging (VLAN Q-in-Q) support (IEEE 802.1ad)
– Private VLAN Edge (PVE)
– Protocol-based VLAN
– MAC-based VLAN
– IP subnet-based VLAN
– Voice VLAN
• Supports Spanning Tree Protocol
– IEEE 802.1D Spanning Tree Protocol (STP)
– IEEE 802.1w Rapid Spanning Tree Protocol (RSTP)
– IEEE 802.1s Multiple Spanning Tree Protocol (MSTP), spanning tree by VLAN
– BPDU Guard
• Supports Link Aggregation
– 802.3ad Link Aggregation Control Protocol (LACP)
– Cisco ether-channel (static trunk)
– Maximum 10 trunk groups, with 8 ports for each trunk
– Up to 16Gbps bandwidth (full duplex mode)
• Provides port mirror (many-to-1)
• Port mirroring monitors the incoming or outgoing traffic on a particular port
• Loop protection to avoid broadcast loops
• Supports E.R.P.S. (Ethernet Ring Protection Switching)
• IEEE 1588 and Synchronous Ethernet network timing (Port1 :12)
• Ingress shaper and egress rate limit per port bandwidth control
• 8x priority queues on all switch ports
• Traffic classification
– IEEE 802.1p CoS
– ToS/DSCP/IP precedence of IPv4/IPv6 packets
– IP TCP/UDP port number
– Typical network application
• Strict priority and Weighted Round Robin (WRR) CoS policies
• Traffic-policing policies on the switch port
• DSCP remarking
• Supports IGMP snooping v1, v2 and v3
• Supports MLD snooping v1 and v2
• Querier mode support
• IGMP snooping port filtering
• MLD snooping port filtering
• MVR (Multicast VLAN Registration)
• Authentication
– IEEE 802.1x port-based/MAC-based network access authentication
– IEEE 802.1x authentication with guest VLAN
– Built-in RADIUS client to cooperate with the RADIUS servers
– RADIUS/TACACS+ users access authentication Access Control List
– IP-based Access Control List (ACL)
– MAC-based Access Control List (ACL)
• Source MAC/IP address binding
• DHCP Snooping to filter distrusted DHCP messages
• Dynamic ARP Inspection discards ARP packets with invalid MAC address to IP address binding
• IP Source Guard prevents IP spoofing attacks
• IP address access management to prevent unauthorized intruder
• IPv4 and IPv6 dual stack management
• Switch Management Interfaces
– Console/Telnet command line interface
– Web switch management
– SNMP v1, v2c, and v3 switch management
– SSH/SSL secure access
• IPv6 address/NTP management
• Built-in Trivial File Transfer Protocol (TFTP) client
• BOOTP and DHCP for IP address assignment
• System Maintenance
– Firmware upload/download via HTTP/TFTP
– Reset button for system reboot or reset to factory default
– Dual images
• DHCP relay and option 82
• User privilege levels control
• NTP (Network Time Protocol)
• Link Layer Discovery Protocol (LLDP) and LLDP-MED
• Network diagnostic
– SFP-DDM (Digital Diagnostic Monitor)
– Cable diagnostic technology provides the mechanism to detect and report potential cabling issues
– ICMPv6/ICMPv4 remote ping
• SMTP/Syslog remote alarm
• Four RMON groups (history, statistics, alarms and events)
• SNMP trap for interface link up and link down notification
• System Log
• PLANET Smart Discovery Utility for deployment management
• Dimension: 444 x 200 x 44.2 mm, 1U height
• Weight: 2672g
• Compliance: FCC Part 15 Class A, CE