PLANET SGS-6341-24P4X on hallittava ja pinottava L3-tason Ethernet-kytkin 24x 10/100/1000 PoE+ kupariportilla, 4x jaetulla SFP-moduulipaikalla sekä 4x 10 Gigasella SFP+ moduulipaikalla. Kytkimen tarjoama PoE budjetti on 370W.

Tekniset tiedot:
• 24x 10/100/1000BASE-T Gigabit Ethernet RJ45 with 24-port IEEE 802.3at/af PoE injector
• 4x 10GBASE-SR/LR SFP+ slots, compatible with 1000BASE- SX/LX/BX SFP
• RJ45 to DB9 console interface for switch basic management and setup
• Power over Ethernet
– Complies with IEEE 802.3at Power over Ethernet Plus, end- span PSE
– Backward compatible with IEEE 802.3af Power over Ethernet
– Up to 24 ports of IEEE 802.3af/802.3at devices powered
– Supports PoE power up to 30 watts for each PoE port
– Auto detects powered device (PD)
– Circuit protection prevents power interference between ports
– Remote power feeding up to 100 meters
• PoE management
– Total PoE power budget control
– Per port PoE function enable/disable
– PoE port power feeding priority
– Per PoE port power limitation
– PD classification detection
– PoE schedule
• IP Stacking
– Connects with stack member via both Gigabit TP and SFP interfaces
– Single IP address management, supporting up to 24 units stacked together
• IP Routing Features
– IP routing protocol supports RIPv1/v2, RIPng, OSPFv2/v3, BGP4/4+
– Routing interface provides per VLAN routing mode
– VRRPv1/v3 protocol for redundant routing deployment
– Supports route redistribution
• Multicast Routing Features
– Supports PIM-DM (Protocol Independent Multicast – Dense Mode) and PIM-SM (Protocol Independent Multicast – Sparse Mode) and PIM-SSM (Protocol Independent Multicast – Source Specific Multicast)
– Supports DVMRP (Distance Vector Multicast Routing Protocol)
– Supports IGMP v1/v2/v3 and MLD v1/v2
• Complies with the IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z Gigabit Ethernet standard
• Supports auto-negotiation and half-duplex/full-duplex modes for all 10BASE-T, 100BASE-TX and 1000BASE-T ports
• Auto-MDI/MDI-X detection on each RJ45 port
• Prevents packet loss flow control
– IEEE 802.3x pause frame flow control in full-duplex mode
– Back-pressure flow control in half-duplex mode
• High performance Store-and-Forward architecture, broadcaststorm control, port loopback detect
• 16k MAC address table, automatic source address learning and aging
• Supports VLAN
– IEEE 802.1Q tag-based VLAN
– GVRP for dynamic VLAN management
– Up to 256 VLANs groups, out of 4041 VLAN IDs
– Provider Bridging (VLAN Q-in-Q, IEEE 802.1ad) supported
– Private VLAN Edge (PVE) supported
– GVRP protocol for Management VLAN
– Protocol-based VLAN
– MAC-based VLAN
– IP subnet VLAN
• Supports Link Aggregation
– Maximum 12 trunk groups, up to 8 ports per trunk group
– IEEE 802.3ad LACP (Link Aggregation Control Protocol)
– Cisco ether-channel (static trunk)
• Supports Spanning Tree Protocol
– STP, IEEE 802.1D (Classic Spanning Tree Protocol)
– RSTP, IEEE 802.1w (Rapid Spanning Tree Protocol)
– MSTP, IEEE 802.1s (Multiple Spanning Tree Protocol, spanning tree by VLAN)
– Supports BPDU & root guard
• Port mirroring to monitor the incoming or outgoing trafficon a particular port (many to many)
• Provides port mirror (many-to-1)
• Supports G.8032 ERPS (Ethernet Ring Protection Switching)
• Quality of Service
– 8x priority queues on all switch ports
– Support for strict priority and WRR (Weighted Round Robin)
– CoS policies
• Traffic classification
– IEEE 802.1p CoS/ToS
– IPv4/IPv6 DSCP
– Port-based WRR
• Strict priority and WRR CoS policies
• Multicast
– Supports IPv4 IGMP snooping v1, v2 and v3; IPv6 MLD v1 andv2 snooping
– Querier mode support
– Supports Multicast VLAN Register (MVR)
• Security
– IEEE 802.1x port-based network access authentication
– MAC-based network access authentication
– Built-in RADIUS client to cooperate with the RADIUS servers for IPv4 and IPv6
– TACACS+ login users access authentication
– IP-based Access Control List (ACL)
– MAC-based Access Control List
– Supports DHCP snooping
– Supports ARP inspection
– IP Source Guard prevents IP spoofing attacks
– Dynamic ARP Inspection discards ARP packets with invalid
– MAC address to IP address binding
• Management IP for IPv4 and IPv6
• Switch Management Interface
– Console/Telnet Command Line Interface
– Web switch management
– SNMP v1, v2c, and v3 switch management
– SSH/SSL secure access
• BOOTP and DHCP for IP address assignment
• Firmware upload/download via TFTP or HTTP Protocol for IPv4 and IPv6
• SNTP (Simple Network Time Protocol) for IPv4 and IPv6
• User privilege levels control
• Syslog server for IPv4 and IPv6
• Supports DDM
• Four RMON groups 1, 2, 3, 9 (history, statistics, alarms and events)
• Supports sFlow
• Supports ULDP
• Supports ULPP (Uplink Protection Protocol)
• Supports ULSM (Uplink State Monitor protocol)
• Supports LLDP/LLDP MED
• Supports DHCP Option82, Option37/38
• Supports ping, trace route function for IPv4 and IPv6