PLANET WGS-4215-16P2S on teollisuuskäyttöön suunniteltu hallittava 18-porttinen 10/100/1000 Ethernet-kytkin, jonka kaikki (16x) Ethernet-kupariportit on varustettu PoE+ virransyöttötuella ja se on varustettu laajannetulla käyttölämpötila-alueella. Kytkimessä on lisäksi 2x SFP- moduulipaikkaa.

WGS-4215-16P2S on rakenteeltaan matala-tyyppinen (”flat”), joten sen seinäasennus on vaivatonta. Laitteessa on myös DIN- sekä magneettikiinnitys mahdollisuudet, joten se saadaan asennettua kaikentyyppisiin koteloihin.

Tekniset tiedot:
• 16x 10/100/1000BASE-T Gigabit RJ45 copper with IEEE 802.3at PoE+ Injector function
• 2x 100/1000BASE-X SFP slots
• Complies with IEEE 802.3at Power over Ethernet Plus, end- span PSE
• Backward compatible with IEEE 802.3af Power over Ethernet
• Up to 16 ports of IEEE 802.3af/802.3at devices powered
• 240-watt PoE budget
• Supports PoE power up to 36 watts for each PoE port
• Auto detects powered device (PD)
• Circuit protection prevents power interference between ports
• Remote power feeding up to 100 meters
• PoE management:
– Total PoE power budget control
– Per port PoE function enable/disable
– PoE port power feeding priority
– Per PoE port power limitation
– PD classification detection
• Intelligent PoE features
– PD alive check
– PoE schedule
• Compact size with fixed wall-mounted, magnetic wall- mounted or DIN-rail design
• IP30 metal case protection
• Supports -10…+60C operating temperature
• Supports ESD 6KV DC Ethernet protection
• Dual power input design:
– 48…56VDC wide power input with polarity reverse protect function
– 3-pin terminal block or DC jack connector
• Hardware-based 10/100Mbps, half/full duplex and 1000Mbps full duplex mode, flow control and auto-negotiation and autoMDI/MDI-X
• Features Store-and-Forward mode with wire-speed filtering and forwarding rates
• IEEE 802.3x flow control for full duplex operation and back pressure for half duplex operation
• 8k MAC address table size
• 10k jumbo frame
• Automatic address learning and address aging
• Supports CSMA/CD protocol
• Supports VLAN
– IEEE 802.1Q tagged VLAN
– Provider bridging (VLAN Q-in-Q, IEEE 802.1ad) support
– Protocol VLAN
– Voice VLAN
– Private VLAN (Protected port)
– Management VLAN
– GVRP
• Supports Spanning Tree Protocol
– STP (Spanning Tree Protocol)
– RSTP (Rapid Spanning Tree Protocol)
– MSTP (Multiple Spanning Tree Protocol)
– STP BPDU Guard, BPDU Filtering and BPDU Forwarding
• Supports Link Aggregation
– IEEE 802.3ad Link Aggregation Control Protocol (LACP)
– Cisco ether-channel (static trunk)
• Provides port mirror (many-to-1)
• Loop protection to avoid broadcast loops
• Ingress/Egress Rate Limit per port bandwidth control
• Traffic classification
– IEEE 802.1p CoS
– TOS/DSCP/IP precedence of IPv4/IPv6 packets
• Strict priority and Weighted Round Robin (WRR) CoS policies
• Supports IPv4 IGMP snooping v2, v3
• Supports IPv6 MLD snooping v1, v2
• IGMP querier mode support
• IGMP snooping port filtering
• MLD snooping port filtering
• Storm Control support
– Broadcast/Unknown unicast/Unknown multicast
• Authentication
– IEEE 802.1X port-based network access authentication
– Built-in RADIUS client to cooperate with the RADIUS servers
– DHCP Option 82
– RADIUS/TACACS+ authentication
• Access Control List
– IPv4/IPv6 IP-based ACL
– IPv4/IPv6 IP-based ACE
– MAC-based ACL
– MAC-based ACE
• MAC Security
– Static MAC
– MAC filtering
• Port security for source MAC address entries filtering
• DHCP snooping to filter distrusted DHCP messages
• Dynamic ARP inspection discards ARP packets with invalid MAC address to IP address binding
• IP source guard prevents IP spoofing attacks
• DoS attack prevention
• SSH/SSL
• IPv4 and IPv6 dual stack management
• Switch Management Interface
– IPv4/IPv6 Web switch management
– Telnet Command Line Interface
– SNMP v1, v2c, v3
– SSH and SSL secure access
• User privilege levels control
• Built-in Trivial File Transfer Protocol (TFTP) client
• Static and DHCP for IP address assignment
• System Maintenance
– Firmware upload/download via HTTP/TFTP
– Configuration upload/download through HTTP/TFTP
– Hardware reset button for system reboot or reset to factory default
• SNTP Network Time Protocol
• Cable diagnostics
• Link Layer Discovery Protocol (LLDP) Protocol and LLDP-MED
• SNMP trap for interface Link-up and Link-down notification
• Event message logging to remote Syslog server
• Four RMON groups (history, statistics, alarms and events)
• PLANET Smart Discovery Utility